Showing posts with label connection. Show all posts
Showing posts with label connection. Show all posts
Thursday, November 13, 2014
ADV7123 Digital to Analog Converter Connection Diagram and Datasheet
This digital-to-analog converter (DAC) integrated circuit is designed for lowest noise performance, both radiated and conducted noise. A recommended connection diagram for the ADV7123 is shown in the following schematic diagram.
According to the ADV7123 datasheet, this device consists of three high speed, 10-bit, video DACs with complementary outputs, a standard TTL input interface, and a high impedance, analog output current source. It used to be applied in digital video systems, image processing, digital radio modulation, color graphics and more.
Additional information on ADV7123 Digital-to-Analog Converter Connection Diagram can be seen in this datasheet of pdf filetype (source: analog.com).
Tuesday, August 12, 2014
Broken Charger connection Alert
The above schema can be useful to detect if the load of any battery charger or plug-in adaptor supply is not properly connected. The load can be a set of batteries to be charged or any other type of battery or low dc voltage operated device.The schema can safely operate over a 3 to 15V range and 1A max. current, provided the supply voltage is about one volt higher than the voltage required by the load.
Parts:
R1______________10K 1/4W Resistor R2_______________1K 1/4W Resistor R3_______________1K 1/4W Resistor (Optional, see Notes) D1,D2________1N4007 1000V 1A Diodes D3______________LED Red (Optional, see Notes) Q1,Q2_________BC557 45V 100mA PNP Transistors BZ1___________Piezo sounder (incorporating 3KHz oscillator) The schema is inserted between the supply and the load, therefore, until a trickle-charging current of at least 100µA is flowing towards the load, D1 and D2 will conduct. The forward voltage drop (about 1V) available across the Diodes, drives Q2 into conduction and, consequently, Q1 will be cut-off. If no appreciable load is connected across the diagram output, Q2 will become cut-off, Q1 will conduct and the Piezo-sounder will beep. Notes: * An optional LED and its series limiting resistor can be wired in parallel to BZ1, as shown in dotted lines in the schema diagram. * In this case you may omit the Piezo-sounder in order to obtain a visual alert only.
Subscribe to:
Posts (Atom)
