Thursday, September 18, 2014

4 x 45 W power amplifier

General description

The TDA8593J is a complementary quad BTL audio power amplifier made in BCDMOS technology. It contains four independent amplifiers in Bridge Tied Load (BTL) configuration. Through the I2C-bus, the diagnostic information of each amplifier and speaker can be read separately. Both front and both rear channel amplifiers can be configured independently in line driver mode with a gain of 20 dB.

Features

  • I2C-bus control
  • Hardware programmable I2C-bus address
  • Can drive a 2 Ω load with a battery voltage of up to 16 V and a 4 Ω load with a battery voltage of up to 18 V
  • DC-load detection: open, short and present
  • AC-load (tweeter) detection
  • Programmable clip detection: 1 % or 3 %
  • Programmable thermal protection pre-warning
  • Independent short-circuit protection per channel
  • Low gain line driver mode (20 dB)
  • Loss-of-ground and open VP safe
  • All outputs protected from short-circuit to ground, to VP, or across the load
  • All pins protected from short-circuit to ground
  • Soft thermal clipping to prevent audio holes
  • Low battery detection.


Circuit Diagram
Circuit diagram for TDA8593

PCB layout of test and application circuit; components bottom

 PCB layout of test and application circuit; copper layer bottom

PCB layout of test and application circuit; components top

 PCB layout of test and application circuit; copper layer top



No comments:

Post a Comment